Bare Knuckle Pickups Forum

Forum Ringside => Pickups => Topic started by: chrisheyes on August 12, 2005, 12:03:41 AM

Title: Identifying a pickup
Post by: chrisheyes on August 12, 2005, 12:03:41 AM

Hi there

I just picked up a strat single coil BKP and would be grateful for some help in identifying which set it comes from, and which position I should use it in.

A multimeter in DC mode gives a reading of 6.4 Ohms

The pole pieces are staggered and have a bevel

Looking at your website Tim, I think it's an early Sultans' Pickup

I've attached a photo, if it's any help !


Thanks in advance

Chris

(http://[img]http://i3.photobucket.com/albums/y78/chrisheyes/IMG_2909.jpg)[/img]

Title: Identifying a pickup
Post by: HJM on August 12, 2005, 06:43:25 AM

Somebody's put shielded cable on that too.....

Title: Identifying a pickup
Post by: chrisheyes on August 12, 2005, 07:54:39 AM

Quote

HJM

Somebody's put shielded cable on that too.....

It is a sheilded cable with one core,the sheilding is attached to the copper wire coil and the single core is soldered to the other side.

Title: Identifying a pickup
Post by: HJM on August 12, 2005, 08:02:04 AM

It's a bridge pickup...red dot!

Title: Identifying a pickup
Post by: HJM on August 12, 2005, 08:05:13 AM

Just checked a Sultan bridge I have here - it's 6.5

Sultan could be right

Title: Identifying a pickup
Post by: chrisheyes on August 12, 2005, 09:45:34 AM

Thanks HJM

What happens if i place it in the neck position ?

Title: Identifying a pickup
Post by: HJM on August 12, 2005, 10:20:56 AM

It'll be a touch hotter, than standard, but I can't see it being too much of a problem - there a touch hotter in the bridge to help balance levels in a set of 3 singles.

Title: Identifying a pickup
Post by: PhilKing on August 12, 2005, 12:48:36 PM

I think it is RWRP too - there is a black dot.  Mind you if someone changed the wire, who knows which way the screen and live are connected.  You can check if it is reverse polarity by putting it over one of your other pickups (top to top).  If they attract it is reverse, if they repel it is the same.

Not sure how you test the winding direction, other than wiring it in with another pickup.  If it is RP, if you get the wiring right it will be hum cancelling and have a strong tone.  If it is very weedy and out of phase, reverse the screen and core wires and try again.

Title: Identifying a pickup
Post by: chrisheyes on August 12, 2005, 02:02:14 PM

Quote

PhilKing Posted: Fri 12 Aug, 2005 12:48 pm    Post subject:  

--------------------------------------------------------------------------------
 
I think it is RWRP too - there is a black dot.

I've looked at the pickup again Phil and the black dot in the photo isn't really there. Must be a trick of the camera flash light.

I checked the poloarity of the magnet and it was repelled by my neck and
bridge pickups in a strat, and attracted to the middle

Thanks for the tips guys.

Looks like I've been given a Bridge pickup from a Sultan's Set  :D

Title: Identifying a pickup
Post by: Tim on August 14, 2005, 08:57:30 PM

Yep, a bridge Sultan it is :D

Title: Identifying a pickup
Post by: chrisheyes on August 14, 2005, 10:40:13 PM

Many thanks Tim  :D