Bare Knuckle Pickups Forum
Forum Ringside => Players => Topic started by: hunter on July 16, 2010, 01:33:30 PM
-
Got a Faber Alu Stoptail and the steel locking studs - makes quite a difference, just more tone and sustain, great!
Pickup is a combo of BKP RiffRaff bridge and MississippiQuenn neck.
Switching between the 4 Channels on the amp, parallel loop activated sometimes for some Delay, Tascam Recorder in the room, that's it:
-Clean until 01:04
-then Crunch until 02::11
-then Meat until 03:02
-then Heat until the end.
I didn't crank up the gains to get more tone.
http://www.netmusicians.org/files/55-4Channels_RiffRaff.mp3
-
Great to hear some more of your clips again. Some nice sounds from the SG. I'm not sure about Alu stoptails - fitted one on my Les Paul for a while - I think I'll try it again, perhaps on my SG.
-
Love the jangle of the cleans - I listened closest to that, because that's where I'd expect to get most from the tailpiece mod (from what I've read, anyway).
The crunch, as usual, is about as far as I go. But I loved the Heat tone. Meat was OK, but Heat was where it was at for me :D
Oh yeah, and "Joe f*cking Perry!" :lol:
-
Sounds good as always! and I agree with Andy, the Heat sounds very nice, meat wasn't as good...
What is the amp?
-
Very nice, Love the crunch tone's bit unfairly biased I like "Dream On" and you did it proud. Heat tone I thought was great too. The clean and meat were nice too just not my favourites.