Hello guys,
I ordered an RGA 8 a few days ago ( I am waiting for it to arrive). The thing is , the pickups are SO BAD so I am going to change them asap, of course to BKP Cold Sweats. I spoked with Tim and he suggested me, CTS/BKP 550K pots, standard shaft and a Jensen 0.022ufd paper in oil cap for volume pot and 500k push pull pot for tone. The spacing of the 8 string humbuckers are all the same, right?? Making sure. lol.
What I don't know is what capacitor I should get for 500k push pull tone pot?? Any suggestions?? I am seconds away from ordering and this is the last thing I need to know, before I proceed.
Thank you very much,
Michael
Depends on what you want it to do. You wanna cut highs for a rounder sound or would you like to cut some unusable bass and get rid of your flubbies when you chug?
More like to cut some unusable bass and get rid of your flubbies when you chug.
I'm a little confused - doesn't it only have one volume, one tone? So you only need one capacitor, the Jensen 0.022ufd Tim suggested. Unless you want to go with a different value?
To be honest, I am still new to the whole thing so I try to figure it out, what's going on and how it works.
I thought you had to get another capacitor for the tone pot either way, since you won't need a second one then I won't.
The thing is though, I might not actually get a tone pot to replace that "mid boost" the guitar has, but replace it with a coil tap and to be honest, I don't know where to find one. Any suggestions where I can get one?? Does BKP store sell these?? Plus, will the CRL 3 way Tele switch or the CRL 5 way switch will fit my guitar??
Thank you very much and sorry if I am being annoying with stupid questions. I am trying to find a solution here, we all have to start from somewhere. :D
I don't know much about the RGA8 (or Ibanez in general), but I see it has active pickups, volume, a 3-way switch and an EQ switch, no tone control.
I'm guessing the EQ won't work with passive pickups (although it might). If you wanted a coil split switch rather than a tone control (or tone control with push-pull) you should just be able to replace the EQ switch with a mini-switch - you can get one from Allparts or WD Music Products (BKP sell an "on-on-on" mini-switch, you could use that for series-split-parallel - but only on one pickup). To split both pickups at the same time, you'd need an "on-on" mini-switch.
If you replace the EQ with a tone pot, you'll need to make the hole bigger so think carefully before doing it!
For the main switch, the CRL 3-way Tele switch should fit - but there's no real need to replace the guitar's existing switch.
the CRL 3 way tele switch, won't be an upgrade?
Quote from: JPMike on August 09, 2011, 10:00:01 PM
More like to cut some unusable bass and get rid of your flubbies when you chug.
Good man. Here ya go. Posted it once, but here it is again.
http://www.metalguitarist.org/forum/guitar-tech-electronics-diy/773-tight-control-simple-passive-bass-cut.html
Quote from: JPMike on August 10, 2011, 01:38:13 AM
the CRL 3 way tele switch, won't be an upgrade?
It'll be a better quality switch, yes.