Bare Knuckle Pickups Forum
Forum Ringside => Tech => Topic started by: Kiichi on January 26, 2014, 02:22:44 PM
-
Hey guys,
I am about to fit a new neck PU on my Ibanez S series and while I am at it I wanne change the wiring of the push pull poti in there. I have an idea and wanne know if it is possible (and how).
I have 1 volume (push pull), 1 tone and a 5 way switch. The wiring without the push pull is:
1. neck
2. split neck + middle
3. middle
4. split bridge + middle
5. bridge
What I would like the push pull to do, if possible is make 2 and 4 out of phase AND in series. That way I could get out of phase without a large loss in output, at least that is my thinking.
I know one or two things about wiring, but this feels a little over my head right now.
For the out of phase part I think I would just have to wire the push pull to flip the wires of the SC middle if I am not mistaken, but how to then bring in the series I am not sure.
Before I end up experimenting a lot I´d rather just ask if any of you fine gentlemen has a diagram or would be so kind to quickly draw one up...or just tell me that this is not possible anyhow.^^
Thanks guys and cheers,
Kiichi
-
Hi,
Check out the guitarnuts2 forum. They have the most comprehensive selection of guitar wiring schematics.
Cheers Stephan
-
Hi,
Check out the guitarnuts2 forum. They have the most comprehensive selection of guitar wiring schematics.
Cheers Stephan
Wow, that sure is a huge resource. Thanks for pointing them out, I´ll see if I can find what I want. Otherwise it will sure help me in figuring it out myself. Thanks again!