Hi folks,
I've a problem with my Boss NS-2: it has a habit of making a loud screeching sound, particularly with my 7 string. Basically, when the gate is in front of the amp it seems to work ok. And with no gate, I get the usual noise. But with the X-pattern to control amp noise, it makes loud screeches with I use my 7 string and/or OD pedals. Strangely enough, putting an OD in front of the gate actually seems to control it a bit more. Any ideas what could be wrong or if I'm doing something stupid?
Signal chain:
Guitar > NS-2 in > NS-2 send > amp in > FX loop send > NS-2 return > NS-2 out > interface (dummy plug in FX loop return and internal load in amp for silent recording with cab impulses)
Does it screech when you don't use the interface?
Just tried it out through two amps and a cab: with my engl screamer everything seems to work fine (just a little less saturation with the gate on). 7 string feeds back a little more than others with no gate, but nothing too bad. My mesa mk5:25 (using the engl speaker) though is actually worse. Feedback on the 7 with any kind of nice thick gain is unusable and rings out even with the gate. I also noticed a volume spike when I switch the gate on. Could it maybe be that the mesa just doesn't get along with this guitar/pickups and the gate just isn't helping?
Just had an idea that seems to be working and makes me think it's more the amp/guitar combo: cutting the 2200 hz slider on the mk v graphic eq reduces the feedback a lot. I'm thinking mk v + bright guitar + nailbombs = wailing uncontrollably. Make sense to anyone else or could I be missing something?
Is there any kind of level control on the loop itself? Some loops don't seem to work that well with noise suppressors or need to be set up a certain way.
I've never used the NS-2 in an X-pattern or in the loop, only in the front end, so I can't really draw on my own experience in that respect. I can say that the ISP Decimator G-String works fine in the loop of my Peavey 6534+ but I suspect Peaveys could be one of the less problematic ones, which is lucky as there are no controls to adjust the loop.
What I would try instead of the X-pattern would be to simply move the whole pedal into the effects loop of your amp.
Guitar > amp in > FX loop send > NS-2 in > NS-2 send > EQ pedals etc -> NS-2 return > NS-2 out > FX loop return
No, there's no controls on the mesa. I'll try it out again tomorrow just in the loop and just in front and see what works. Thanks for the advice guys!
One more thing: if you are currently using a 9V power supply try it with a fresh 9V battery instead. At least that way you can check if it is the power supply that's causing the noise
^ Yeah.
And yeah I think the NS2 has a little bit of a volume boost when engaged. That might not be helping.
Right, after trying the suggestions I think it's just been too much treble/upper mids for the Mark V to take. No idea why it was behaving so weirdly for direct recording, but with a speaker it's acting more normal and I think the gate is actually fine. With my 7 string, switching to the MXR ZW OD instead of the Green Screamer helped and a big cut at 2200 Hz on the eq fixed it completely. Another guitar (with Miracle Man pickups instead of Nailbombs) didn't have the problem at all. Maybe I'll switch to a more low end focused pickup for the 7 sometime.