Bare Knuckle Pickups Forum
Forum Ringside => Pickups => Topic started by: Sam Chadwick on February 08, 2021, 04:02:03 PM
-
Hi all, has anyone bought one of these from BKP? what is the installation process - does it require much soldering etc?
Good to be back on here it's been a long time!
-
t's a pre-wired pickguard, so you would just have to solder the two wires to the output jack
-
is one of those 2 the ground? a guide i read mentioned some strats have 2 ground wires, not sure if this was in addition to 2 wires to output jack
-
Oh you will will have to connect a ground wire from the bridge to the pot where the other grounds are located. On a Strat this will generally be from the claw. There might also be a ground wire that someone has added for the cavity shielding (if present).
-
have you sheilded your guitar with conductive tape or paint? if not I recommend doing it and then hooking up the kit, which should be just connect to the output jacks as dave said.