Bare Knuckle Pickups Forum

Forum Ringside => Guitars, Amps and Effects => Topic started by: crispsandwich on September 06, 2006, 11:11:02 AM

Title: Can I run the speaker out from my Epi Valve Junior.....
Post by: crispsandwich on September 06, 2006, 11:11:02 AM

into my X V-amp? I know it's probably a ridiculous question, but I'm really dumb when it comes to speaker outs. Will this blow up my V-amp?

Title: Can I run the speaker out from my Epi Valve Junior.....
Post by: FELINEGUITARS on September 06, 2006, 11:34:04 AM

The speaker out should only go into a speaker with the right impedance load for the Valve Junior
You run the risk of damaging both bits of equipment otherwise

Title: Can I run the speaker out from my Epi Valve Junior.....
Post by: crispsandwich on September 06, 2006, 11:50:05 AM

OK, thanks very much for that :).

Title: Can I run the speaker out from my Epi Valve Junior.....
Post by: HTH AMPS on September 07, 2006, 09:58:27 PM

In addition to what Feline said, the only way you could run the speaker output into the X V-amp is if you used something like a Hotplate.  The Hotplate has a line-out that allows you to run a line level signal.

 :twisted: