Bare Knuckle Pickups Forum

Forum Ringside => Tech => Topic started by: ChrisMetal on October 10, 2006, 10:37:27 PM

Title: Replacing a licensed Floyd Rose?
Post by: ChrisMetal on October 10, 2006, 10:37:27 PM

Anyone know how to replace a licensed floyd rose with an original? Any good step by step guides out there. Or has anyone here done it?

Title: Replacing a licensed Floyd Rose?
Post by: dave_mc on October 11, 2006, 12:31:39 PM

what guitar is it, and what brand of licensed floyd?

Title: Replacing a licensed Floyd Rose?
Post by: ChrisMetal on October 11, 2006, 09:25:09 PM

Its a Dean Razorback, and the tremolo just seems to be a standard licensed design. its definately not a pro. I wanna replace the licensed floyd with an original, as this is one of the things that the rather expensive Razorback has over the cheaper ones.

Title: Replacing a licensed Floyd Rose?
Post by: dave_mc on October 11, 2006, 10:10:57 PM

best bet is to go to www.floydrose.com to get the routing templates and then do a load of measuring...

Title: Replacing a licensed Floyd Rose?
Post by: gingataff on October 12, 2006, 01:45:27 AM

I recently discovered my Ibanez Edge and Schaller floyd rose (II) have the same stud spacing,

woo hoo I thought, chance for a little experimentation...

but the routing is so completely different I couldn't even get them in the holes properly.....

The moral is, FRs come in all shapes and sizes so a bit of woodwork is likely.

Title: Replacing a licensed Floyd Rose?
Post by: dave_mc on October 12, 2006, 12:47:21 PM

^ agreed, that's why i suggested some frantic measuring, just in case he's lucky.