• Welcome to Bare Knuckle Pickups Forum.
 

Grounding problem? (buzzing noise)

Started by Transcend, April 30, 2008, 12:10:07 PM

Previous topic - Next topic

Transcend

i have switched the miracle man from my agile into my vintage (and i must say it sounds awesome)

but there is a buzzing sound which gets greater if i touch the pickup.

however it doesnt happen if i touch the floyd or any of the controls or the input jack.

Is this a grounding problem? if so what is the best way to solve this?

i have the red wire hooked up to the pickup selector and the black & left the other two (black & green i think) taped together and the bare and other wire are connected together to the back of the tone pot.

Twinfan

You want:

red to selector
black and bare to back of a pot
green and white taped together not attached to anything

Is that what you've got?

PhilKing

Red to selector, leave green & white taped together and black and bare to back of volume or tone pot (as long as there is a ground wire to the tone too.  It is possible you have a ground loop if there are other grounds connecting.  it is better to take all the grounds to one spot to prevent this.
So many pickups, so little time

Transcend

Quote from: TwinfanYou want:

red to selector
black and bare to back of a pot
green and white taped together not attached to anything

Is that what you've got?

yeah thats what i have.

my only other ground is from the floyd to the pickup selector which is how it was wired before.

so should i move the one from the pickup selector to the pot then?