• Welcome to Bare Knuckle Pickups Forum.
 

Blackstar pedal Power Supply trick

Started by hamfist, May 16, 2008, 07:41:32 PM

Previous topic - Next topic

hamfist

I've always known that the power supplies to the Blackstar pedals can tend towards causing a fair bit of hum.
  Anyway, I was moving my HTdist's PSU around again trying to find the "point of least hum" in comparison to the rest of my pedalboard after yet another jiggle round of the board.  Just by chance I did something different I haven't done before ..... I turned the power supply upside down. And Voila, the hum virtually disappears.  Big result !!

 Just something that might work for you, or might not. But it's worth a try.

opprobrium_9

Quote from: hamfistI've always known that the power supplies to the Blackstar pedals can tend towards causing a fair bit of hum.
  Anyway, I was moving my HTdist's PSU around again trying to find the "point of least hum" in comparison to the rest of my pedalboard after yet another jiggle round of the board.  Just by chance I did something different I haven't done before ..... I turned the power supply upside down. And Voila, the hum virtually disappears.  Big result !!

 Just something that might work for you, or might not. But it's worth a try.

can you show a picture?  I am having a hard time visualizing it.
BKPz: Nailbomb+VHII, more to come...

maverickf1jockey

The power supply for the Blackstar pedals has a standard 3-pin plug that goes into the mains socket and the transformer is in a roundish box further along the cable (which has a flattened face for obvious reasons).

I think he meant that the transformer was upside down rather than the plug as they are separate in this circumstance.
I too use chicken as a measurement.

hamfist

Quote from: maverickf1jockey
I think he meant that the transformer was upside down rather than the plug as they are separate in this circumstance.

Exactly