Quote from: Lukie on July 29, 2009, 10:53:40 PM
I have a new amp with a weird "feature/fault". If you turn up the gain on the distortion channel, you can hear it faintly through the clean channel. You can even set the clean channel gain to zero, and you only get the bleeding through signal from the distortion channel. It was battered around a bit in transport so I am not sure if its a factory error or damaged in transit. :(
Has anyone experienced this before??
This is quite common, and perfectly normal.
It is either caused by capacitive cross talk between the two channels and/ or by feed through from imperfect switching elements.
In general use this should not be a problem, and "curing" it on most amps could be tiresome.
In an SLO100, as mentioned above, this is actually a "feature" of the channel switching. Essentially the clean channel is never switched off, so when the gain channel is on then the clean channel is swamped by the hotter signal.
Also the two channels are out of phase, so there will be some signal cancellation. I don't know if this contributes much to the SLO100 sound or not. When we've experimented with this type of circuit we've not incorporated this "feature".