• Welcome to Bare Knuckle Pickups Forum.
 

Mains hum that disappears with hand contact on all my equipment.

Started by Hammerheart, January 19, 2013, 08:57:18 PM

Previous topic - Next topic

Hammerheart

On all amps, all guitars (apart from the one with an emg in it) in all sockets around the house i get a hum which disappears when i touch the metalwork of the guitar. Ive checked the sockets with my socket tester and it appears they are wired corretly and not missing the earth. Any ideas on what the problem might be? I've only lived here just over a month and it never used to do it in my old home. I'm an electrician by trade but I'm stumped by this. I'm going to check inside the fuseboard in a second to see what I can see.

The most annoying thing about this is the slight popping sound when i come into contact with the guitars. It's getting to be annoying now.
Gibson LP Trad 2011 w/BKP Old Guard
Gibson CME SG 61 Standard w/T-Types
Gibson SG 61 Standard w/61R/61T (yuk)
Orange 100w Rockerverb 100 mkiii
Laney Studio 3w Superlead
Marshall DSL100HR

Twinfan

If you're a sparkie, and you don't know, how are you expecting us to?????!!!  :?  :lol:

JJretroTONEGOD

Quote from: Hammerheart on January 19, 2013, 08:57:18 PM
On all amps, all guitars (apart from the one with an emg in it) in all sockets around the house i get a hum which disappears when i touch the metalwork of the guitar. Ive checked the sockets with my socket tester and it appears they are wired correctly and not missing the earth. Any ideas on what the problem might be? I've only lived here just over a month and it never used to do it in my old home. I'm an electrician by trade but I'm stumped by this. I'm going to check inside the fuse-board in a second to see what I can see.

The most annoying thing about this is the slight popping sound when I come into contact with the guitars. It's getting to be annoying now.

is the inside of your electric guitar shielded? it needs to be grounded properly! take it to a guitar tech
listen to my music for free here:
[url="https://soundcloud.com/bentyreman"]https://soundcloud.com/bentyreman[/url]

sjwebb90


Does your new abode have dimmer switched lighting?

This are notorious for creating nasty buzzing on guitars and amps when the lights are switched on.

Just a thought, as I have the same issue at my gaff when the dimmer is switched on downstairs! Turn the dimmer off and the noise goes away!

PRS Stop tail CU22 Crawler covered  set,  PRS Trem CU22 Abraxas covered set, PRS SC Trem Crawler covered set & (Charval 475 HSS- Holydiver, Irish Tours open set)

Hammerheart

Quote from: Twinfan on January 20, 2013, 12:37:39 AM
If you're a sparkie, and you don't know, how are you expecting us to?????!!!  :?  :lol:

Lol yeah I know. Trouble is I can't find a single thing wrong with the electrical installation but its affecting all my guitar amps. There's only one dimmer and I've made sure its off.
The fact it goes away when I earth the guitar with my body means something isn't earthed but everything tests out ok. It's happening with all my guitars and all 4 amps

As a sparky this isn't the kind of thing I'm usually asked to find out. I certainly don't deal with electronics in any way.

I'll have to unplug everything in the house tomorrow. Hopefully I can isolate the problem.
Gibson LP Trad 2011 w/BKP Old Guard
Gibson CME SG 61 Standard w/T-Types
Gibson SG 61 Standard w/61R/61T (yuk)
Orange 100w Rockerverb 100 mkiii
Laney Studio 3w Superlead
Marshall DSL100HR

Twinfan

Have you tried plugging into different sockets around the house to see if that helps?

darkbluemurder

Quote from: Hammerheart on January 19, 2013, 08:57:18 PM
On all amps, all guitars (apart from the one with an emg in it) in all sockets around the house i get a hum which disappears when i touch the metalwork of the guitar.

Assuming the electric sockets are wired correctly and the amp's safety grounds are intact, a bit of hum reduction when touchng the metal parts is normal. The reason is that once you touch a metal part your body gets grounded and acts like a shield. The effect can be minimised by shielding the wiring in the guitar as much as possible. Putting covers on humbuckers also helps in that regard. However, it will not be possible to eliminate all of it since the pickups are susceptible to picking up stray noises as well, and if you shield them completely in a case you shut them off from the strings rendering them unfunctional.

The standard EMG set up does not ground the strings so you will not have the additional shielding effect by touching the strings since your body will not be connected to ground.

If you get crackling or loud popping you could have problems with static charge. This happens with guitars with plastic pickguards sometimes. Putting some aluminum foil underneath the pickguard helps and also adds shielding.

Cheers Stephan

Hammerheart

Quote from: Twinfan on January 21, 2013, 08:19:03 AM
Have you tried plugging into different sockets around the house to see if that helps?

yeah. Its on all sockets and all circuits.

Gibson LP Trad 2011 w/BKP Old Guard
Gibson CME SG 61 Standard w/T-Types
Gibson SG 61 Standard w/61R/61T (yuk)
Orange 100w Rockerverb 100 mkiii
Laney Studio 3w Superlead
Marshall DSL100HR

Hammerheart

Quote from: darkbluemurder on January 21, 2013, 10:56:40 AM
Assuming the electric sockets are wired correctly and the amp's safety grounds are intact, a bit of hum reduction when touchng the metal parts is normal. The reason is that once you touch a metal part your body gets grounded and acts like a shield.

If you get crackling or loud popping you could have problems with static charge. This happens with guitars with plastic pickguards sometimes. Putting some aluminum foil underneath the pickguard helps and also adds shielding.

Cheers Stephan

It must be a combination of these two things. I've exhausted everything else. I just did a test by holding the metal pipe that goes  into the radiator next to my amp (in effect grounding my body before I touch the guitar) and the popping problem goes away. Looks like I'm all charged up with static. Looks like I will have to attach an earth lead to myself before I play from now on lol.
Gibson LP Trad 2011 w/BKP Old Guard
Gibson CME SG 61 Standard w/T-Types
Gibson SG 61 Standard w/61R/61T (yuk)
Orange 100w Rockerverb 100 mkiii
Laney Studio 3w Superlead
Marshall DSL100HR

JJretroTONEGOD

Quote from: darkbluemurder on January 21, 2013, 10:56:40 AM
Quote from: Hammerheart on January 19, 2013, 08:57:18 PM
On all amps, all guitars (apart from the one with an emg in it) in all sockets around the house i get a hum which disappears when i touch the metalwork of the guitar.

Assuming the electric sockets are wired correctly and the amp's safety grounds are intact, a bit of hum reduction when touchng the metal parts is normal. The reason is that once you touch a metal part your body gets grounded and acts like a shield. The effect can be minimised by shielding the wiring in the guitar as much as possible. Putting covers on humbuckers also helps in that regard. However, it will not be possible to eliminate all of it since the pickups are susceptible to picking up stray noises as well, and if you shield them completely in a case you shut them off from the strings rendering them unfunctional.

The standard EMG set up does not ground the strings so you will not have the additional shielding effect by touching the strings since your body will not be connected to ground.

If you get crackling or loud popping you could have problems with static charge. This happens with guitars with plastic pickguards sometimes. Putting some aluminum foil underneath the pickguard helps and also adds shielding.

Cheers Stephan

+1 and adding to that conductive copper is also ideal for lining the inside of the guitar
listen to my music for free here:
[url="https://soundcloud.com/bentyreman"]https://soundcloud.com/bentyreman[/url]

sjwebb90

PRS Stop tail CU22 Crawler covered  set,  PRS Trem CU22 Abraxas covered set, PRS SC Trem Crawler covered set & (Charval 475 HSS- Holydiver, Irish Tours open set)

darkbluemurder


BigB

Have: Crawlers, BGF 50/52s, Mules, ABomb, RiffRaff
Had : Slowhands (n&m), Trilogy (b)