Ole - if I had known it was for Petrucci wiring I would have asked for a reverse magnet option in one pickup for you
Really no issue at all. I am someone who prefers stock magnets. For my P90 set I also got stock cause I like that extra full frequency response. Even if the Petrucci wiring is meant to be humcancelling. Since I use that position for lower gain sounds mostly it does not really matter much anyhow. Plus I am likely to try 1k resistors in series with the shut of coil (Prs style) at one point and that will also slightly reduce hum, so either way I am good.
Plus I can always turn on my ISP Decimator clone ;)
I will likely have another shot at getting this sorted on wednesday since it looks like I have time there to do it in calm.
I will aim to get it to work with the slug coils. Then again that is what I thought would happen with what I currently run...oh well, wednesday.
Cheers guys!
Hey Kiichi - if you don't mind me asking, as I'm taking the thread off-topic a bit here, what wiring did you end up using for your BKPs into your JP 3-way switch PC board? I'm getting ready to put my BKP's in my JP6 but am a bit concerned about color differences and getting the right wires to the right places on the board. I found a few references online to wiring diagrams, but they're for the Dimarzio pups, not BKP. Plus I'm a pickup mod newbie so tackling a lot of new issues all at once... :)
Sorry for the late reply, forgot to check here for a while.
I must admit I have not found a relaxed enough moment to fix up the middle position yet. University, among other things, keeps me too occupied. When I have free enough time I like to spend it playing right now.
Soon as I get around to it I will attempt to set it up so I have the necks screw coil and the a bridge coil actived. IŽll actually have to see which one I will go for with the bridge...weŽll see which stays on when I just convert the dimarzio diagramms, though I must say I would be interrested to hear how it sounds with the two screw coils active (the two outer ones in my case), so I will try that at one point. Could be cool I imagine. Might take a PRS style resistor in series on the bridge (turning the slugcoil only down instead of off) so that it is not that terrible thin and weak to keep some balance, but hey.
IŽll write here again once I have done somthing. Dunno when that will be though tbh.