• Welcome to Bare Knuckle Pickups Forum.
 

Any tips on how to melt old solder?

Started by Crazy_Joe, February 22, 2007, 12:24:49 PM

Previous topic - Next topic

Crazy_Joe

I had the same problem with my Explorer but this Ibanez solder where the ground wire goes is so tough!

It will not melt so i can't get the old pickups out and in the process i am destroying the other wires.
Black Dogs

Previous BKP's: Riff Raff, Holy Divers, Painkillers, C. Warpig, Nailbomb, Miracle Man.

Antag

What wattage of soldering iron are you using?
BKPs: HD, MM, NB, PK, CS, Ab (b&n); Am (b only); VHII, Tril (n only); IT, Slow, Sult (m&n)

Crazy_Joe

I have no idea it says 50Hz 240v/24v and 50va on it.
Black Dogs

Previous BKP's: Riff Raff, Holy Divers, Painkillers, C. Warpig, Nailbomb, Miracle Man.

Crazy_Joe

Wooo finally got threough it, though i'm a bit worried about the volume pot as it's gettgin quite hot.
Black Dogs

Previous BKP's: Riff Raff, Holy Divers, Painkillers, C. Warpig, Nailbomb, Miracle Man.

metal_god

should be fine aslong as you dont heat the pot for too long, try using the flattest part of the iron too the tip isnt great sometimes and remember to scratch all the cr@p from previous soldering....

Spud

When melting solder it's a good idea to add a little fresh solder to the iron's tip first, as this helps conduct the heat to the old solder more efficiently.

Also turn the pot down to zero, so if too much heat is conducted to the carbon track inside the pot, the damage will not be at an audible part of the pot's travel.

A quick word on watts: the wattage does not determine temperature, rather how quickly the heat that is conducted away from the iron is replaced. a 25-30watt iron is fine for guitar electronics.

Crazy_Joe

Yeah, when you put a bit of solder on the iron's tip it's called 'tinning up the iron' i think, well that's what i learned in electronics.
Black Dogs

Previous BKP's: Riff Raff, Holy Divers, Painkillers, C. Warpig, Nailbomb, Miracle Man.