• Welcome to Bare Knuckle Pickups Forum.
 
Main Menu

loose studs

Started by gwEm, July 02, 2007, 11:28:26 AM

Previous topic - Next topic

gwEm

i'm upgrading the bridge on one of my guitars.

the problem is the new studs are a shade less wide than the old ones - and they slip very easily in the old holes.

what would be the solution to this problem?

i was thinking of supergluing the new studs in - but it feels like a bodge.

would the right solution be to fill the old holes with doweling and rebore slightly smaller? that sounds like a job for an experienced luthier
Quote from: AndyRyou wouldn't use the meat knife on crusty bread but, equally, the serrated knife and straight edge knife aren't going to go through raw meat as quickly

Metal-Assmoney

actually, a good solution to that would be to buy some wood filler and kind of coat the edges of the holes lightly and then let it dry

WezV

I would plug and redrill  if there was more than a mm difference.  I would super glue or epoxy it if was less - epoxy will fill any gaps better.  Makes it damn hard to get them out again though so dont use to much - a little goes a long way

depending on the gap and the type of stud  and the value of the guitar i might be tempted to shim the hole with a bit of veneer just to make it a tight fit.  This works better if the post has a lip at the top that will cover up the fix.
[url=http://www.wezvenables.co.uk]www.wezvenables.co.uk[/url]

WezV

Quote from: Metal-Assmoneyactually, a good solution to that would be to buy some wood filler and kind of coat the edges of the holes lightly and then let it dry

Wood filler doesnt really have any structural strength - if i was going to use a filler i would mix epoxy with wood dust to make my own high strength filler
[url=http://www.wezvenables.co.uk]www.wezvenables.co.uk[/url]

Metal-Assmoney

naturally i do that, its been so long since i had to use it i totally spaced it out.

gwEm

the studs touch the edge of the hole - but dont grip. i'll buy some epoxy on the way home tonight.

thanks once more wezv!

G
Quote from: AndyRyou wouldn't use the meat knife on crusty bread but, equally, the serrated knife and straight edge knife aren't going to go through raw meat as quickly

WezV

if there was a bridge wire dont foget to re attach it before gluing the post in place

sounds daft but its always worth pointing out!!
[url=http://www.wezvenables.co.uk]www.wezvenables.co.uk[/url]