• Welcome to Bare Knuckle Pickups Forum.
 

Earlier problem sorted, now nothing but Hum!

Started by Brow, September 19, 2005, 06:40:14 PM

Previous topic - Next topic

Brow

Hey guys.

I think I found a way around my earlier problem with the screws (shortened the screws and used springs instead of spacers) and that seemed to solve the problem.

I soldered the 3 wires left over fromt he scratchplate;

'hot' wire to jack socket
Ground wire to trem claw
Ground waire to jack socket

I plugged the guitar into an amp on the clean channel and got nothing but a loud hum.

I re-checked all my solder joints and made sure nothing was touching where it shouldn't be and all appears well.

Anyone have any suggestions as to what I should check next and ow to fix whatever is wrong.

Craig
Selling lots of gear, enquire within!......

PhilKing

Check the jack connections.  The hot wire goes to the tip, the ground to the barrel.
So many pickups, so little time

HJM

Apache,VHII,Emerald,Nailbomb,MiracleMan,StormyMonday,BlackDog,Trilogy,Mothersmilk,Sultans+Sinner

Tim

Ditto,

White goes to hot/tip of jack and black goes to ground/sleeve.
Tim
BKP - "Wound, made and played the traditional way --- by hand!" Amen.

Brow

I found the cause of my problem:

It was a dodgy jack socket!

I have a few knocking around and it turns out I mixed up the 1 I took off the guitar with an old 1 I had lying around that didn't work, and I didn't realise  :roll:

I haven't got any strings on the guitar yet, but i tapped them with a screwdriver and they all work.

So I'm off to re-string it and give them a try out!  :D
Selling lots of gear, enquire within!......

Tim

Tim
BKP - "Wound, made and played the traditional way --- by hand!" Amen.

Ratrod

Now string it up and find the pickup's sweet spots. :P
BKP user since 2004: early 7K Blackguard 50

Brow

Quote from: TimWell done Brow........patience prevails!

Thanx Tim :D

If I was less of a dunce it wouldn't have happened in the 1st place, but all seems ok now 8)

I'm still kinda expecting problems as regards my having to change the mounting screws on the Crawler, but atleast I got the soldering dun :D
Selling lots of gear, enquire within!......

Brow

Quote from: RatrodNow string it up and find the pickup's sweet spots. :P

Yup, that's my next course of action :)
Selling lots of gear, enquire within!......

Tim

The easiset thing to do is use the longer screws, get the height right and cut of the spare with a pair of snips.
Tim
BKP - "Wound, made and played the traditional way --- by hand!" Amen.

Brow

Quote from: TimThe easiset thing to do is use the longer screws, get the height right and cut of the spare with a pair of snips.

Thanx for the idea Tim :)

I've managed to get a balance between the pickups as of yet, but I'll do as you suggest the next time I change the strings :)

Craig
Selling lots of gear, enquire within!......