• Welcome to Bare Knuckle Pickups Forum.
 
Main Menu

crimping

Started by CaffeineJunkie, March 03, 2007, 06:47:10 PM

Previous topic - Next topic

CaffeineJunkie

ok... so i was sitting at work today and came up with the following idea...

instead of soldering the pickups in, could you not run the wires through to the different parts of the guitar  i.e. to the volume/tone pots and the p/up switch etc. and then crimp a bullet connector to the wires going into the p/up cavity, so that when you wanted to change the p/ups all you gotta do is crimp the wire on the p/up and bung it in....

is that possible or am i talking gibberish?


Cheers

James
PRS Starla for sale, see Seconds out section...

Dennis

Well, you can always make a connector thingy...why not....EMG equipped guitars have that sometimes (always?) too!
Nailbombs, Irish Tours, C-Warpig7, Cold Sweat7, Apaches

Canadian Steve

Hey C Junk, I don't know that much about guitar electrics but I had a Kinman Nosolder kit a while back, which allowed you to screw the connection into place with a tiny screw.  Check out:
http://www.kinman.com/html/myProducts/strats.htm#NoSolder
BKPS: Cryogenic Apache set, Mule set, Riff Raff, Stormy Monday.

CaffeineJunkie

looks kool, might give it a try on my ibanez when it arrives
PRS Starla for sale, see Seconds out section...

Muzzzz

Good thinking, CJ!

Sounds like a really good idea. Why didn't I think of that?
{Insert witty signature HERE}