• Welcome to Bare Knuckle Pickups Forum.
 

Cold Sweat for the Neck?

Started by Liquid, December 15, 2006, 11:37:52 PM

Previous topic - Next topic

Liquid

That clip sounded pretty nice, thaks for the link

I still haven't gotten anything yet, So I'm ressurecting this thread with the hope of finding something. My main concern is the CS's cleans. I Like my cleans pretty bassey with a lot of mids too but most Importantly I like them Clean! Breakup sounds great a lot of the time, and sometimes I go for that (Depending on what I'm playing) but for the most part I want my cleans clean And I'm wonderin would the CS push them to break up much earlier?

Liquid

Can anyone help me out with this? I'm really anxious to get another BK after realising the huge improvement my MM in the Bridge made. I'm 90% sure the CS is what I want for the neck, I'd really love something that can give great clean cleans and a distortion something like this (Particularly the sound between about 1:20 and 1:40) :

http://www.youtube.com/watch?v=5NfZBvRvkIg

I Love the distinctive sound of a neck pickup for leads, especially one that's being driven hard. I want a neck pickup that can handle lots of distortion without sounding like a bridge pickup and instead retaining that neck 'mellowness'

JoshuaLogan

how nice the cleans are is going to depend on how much headroom your amp has heh. and also, I suggest getting push-pull pots for your LP and wiring it up so you can split the coils to mimic a single coil sound. the cleans will be much nicer with it split. and if you did this, you could even get a higher output pickup, because the coldsweat split would only be around 4k which is very low output. I think most vintage single coils are around 8k... judging from that, maybe a miracle man neck would be a better match packing more punch in the neck and when split still doing nice cleans.

Liquid

Unfortunately, my amp doesn't have a great amount of headroom. It's not bad, but not exactly a twin reverb either.

I'd also rather try and avoid going for splitting or coil tapping. I'm not really experienced enough to try that myself and I doubt my closest shop would be able to do it for me. They charge €50 to install a new pickup :/

Sifu Ben

It's not really any harder than installing a pickup, you just need to fit a new pot and wire it slightly differently.
Cold Sweat, Nailbomb 7b, Cold Sweat 7n

Liquid

I still wouldn't feel comfortable trying it myself, I've never installed a pickup before and haven't done much soldering either. And if this shop charges €50 to just install a pickup I'd hate to know how much they'd want to do a coil split...