• Welcome to Bare Knuckle Pickups Forum.
 

Adding a killswitch?

Started by Mr Ed, February 27, 2008, 10:49:52 PM

Previous topic - Next topic

hamfist

Quote from: Mr EdI'm a gimp, could you knock me up a little wiring diagram?

:)

Also, how can you guarentee the tone control won't move? I know it's a bit of a stretch but isn't there some chance while it's rattling around in the cavity that it might turn a little?

I basically used the wiring instructions from this vid - http://youtube.com/watch?v=LUpkQ8wb4j4&feature=related .
 I, obviously  didn't drill the extra hole that the video-maker did though, as I used the tone pot hole.
  I have wrapped the "internal" tone pot with insulating tape to ensure it doesn't get turned at all. I also packed out the cavity with bubble wrap, to stop any rattles, or any false connections being made by the tone pot moving around inside.

Mr Ed

Quote from: hamfist
Quote from: Mr EdI'm a gimp, could you knock me up a little wiring diagram?

:)

Also, how can you guarentee the tone control won't move? I know it's a bit of a stretch but isn't there some chance while it's rattling around in the cavity that it might turn a little?

I basically used the wiring instructions from this vid - http://youtube.com/watch?v=LUpkQ8wb4j4&feature=related .
 I, obviously  didn't drill the extra hole that the video-maker did though, as I used the tone pot hole.
  I have wrapped the "internal" tone pot with insulating tape to ensure it doesn't get turned at all. I also packed out the cavity with bubble wrap, to stop any rattles, or any false connections being made by the tone pot moving around inside.

Nicely done, sounds good. Ta.
[url=www.myspace.com/endever101]EndEveR[/url] & [url=www.last.fm/user/Captain_Stubert/]LastFM[/url]