• Welcome to Bare Knuckle Pickups Forum.
 

Pickup Rings for SG200

Started by MrBump, October 07, 2008, 12:44:56 PM

Previous topic - Next topic

MrBump

Quick question - my Yam SG 200 has 3 screws in each pickup ring holding the pickups. 

I haven't opened it yet - I'd assume it's pretty straight forward to replace the rings?  Are "angled rings" all angled to the same degree?  Or will I need to sculpt the rings to fit a curved body?

Or would I just drill another hole in the existing rings to accommodate?

Cheers.

Mark.
BKPs Past and Present - Nailbombs, Mules, Blackguard Flat 50's, VHII's & Trilogy Suite with Neck & Bridge Baseplates!

WezV

either way works,

if it was a carved top you would maybe have a little more fitting if you changed the rings but i wouldnt worry about it on a flat top guitar
[url=http://www.wezvenables.co.uk]www.wezvenables.co.uk[/url]

Ratrod

I switched mine when I switched to BKP's. The stock pickup rings won't work with BKP's. They're not wide enough and they have three adjustment screws instead of two.

I took my SG to a guitar shop and test fitted several pickup rings.
BKP user since 2004: early 7K Blackguard 50

MrBump

Quote from: Ratrod on October 09, 2008, 11:16:40 AM
I switched mine when I switched to BKP's. The stock pickup rings won't work with BKP's. They're not wide enough and they have three adjustment screws instead of two.

I took my SG to a guitar shop and test fitted several pickup rings.

Cheers, Mr Rod.  Did you need to get any of the wood chisled away too?
BKPs Past and Present - Nailbombs, Mules, Blackguard Flat 50's, VHII's & Trilogy Suite with Neck & Bridge Baseplates!

Ratrod

No, I didn't need to chip anything away.Buti t was a tight fit. I did have to drill new holes for the rings.
BKP user since 2004: early 7K Blackguard 50