• Welcome to Bare Knuckle Pickups Forum.
 

small powered pedal boards

Started by Dmoney, July 14, 2009, 01:17:53 AM

Previous topic - Next topic

Dmoney

anyone use smaller powered pedal boards for something like a wah and 3 or 4 boss sized FX.

i always have bad luck with noise when powering FX from mains outlets. but id like to move to a powered pedal board as long as the power is hum free-ish or whatever.#

any ideas?

Zaned

#1
Sounds like you want the power outlet to be built-in on the pedalboard. That was one option for me too, when I was building my board. However, they were not easy to come by here and I ended up ordering a separate board and a separate power, namely the Voodoo Lab Pedal Power II Plus. Isolated outputs and the works, I have only good things to say about it. Noiseless and can give power to almost any pedal.

If you combine that with something like a T-Rex ToneTrunk (http://www.t-rex-engineering.com/Default.aspx?ID=95), you can do whatever you like.

And then the boards with built-in power one example: http://www.furmansound.com/product.php?id=SPB-8
Whatever you end up buying, I strongly recommend that you pay attention if the power outlets are isolated. Ground loops are not nice, and I believe that they occur much more easier if you combine pre-amp effects and effects in the loop from the same power. Unless the outputs are isolated of course. But I have a gut feeling that you're not gonna  bother with fx loop (which I have my delay on), so isolated outputs might not be a definitive requirement.

My 0.02 euros.

-Zaned
Paths are for followers.

sjwebb90

Make sure you get yourself a regulated Power Supply.

I use one of these from Maplin Electronics, more than enough to power most pedals and it doesn't hum
http://www.maplin.co.uk/Module.aspx?ModuleNo=32754

Daisy Chain lead
http://www.maplin.co.uk/module.aspx?moduleno=1410

Cheers
SJ
PRS Stop tail CU22 Crawler covered  set,  PRS Trem CU22 Abraxas covered set, PRS SC Trem Crawler covered set & (Charval 475 HSS- Holydiver, Irish Tours open set)

sgmypod

I use the johnny pedalfreak ones..think a few others do on here..no noise
Autotune My Arse

Crawler,nailbomb & Ltd Ed Emeralds, apache, now riff raff..EX- N/bomb, IT, Mquee

badgermark

Quote from: sgmypod on July 14, 2009, 05:43:09 PM
I use the johnny pedalfreak ones..think a few others do on here..no noise

Same, i use the JSF one too. Reliable and pretty small, no problems running all of my home made pedals.
Mississippi Queens, Holydiver.

sgmypod

I run homemade and general make ones no problems with noise..even at dodgy practice rooms
Autotune My Arse

Crawler,nailbomb & Ltd Ed Emeralds, apache, now riff raff..EX- N/bomb, IT, Mquee