• Welcome to Bare Knuckle Pickups Forum.
 

Wiring help needed

Started by Sifu Ben, September 25, 2010, 05:32:21 PM

Previous topic - Next topic

Sifu Ben

I'm replacing all the electrics on a guitar, and I'm a little confused. The wire that came with the parts is the cloth and wax wire here http://www.axesrus.com/axeElectronicsWire.htm
The wire on the original loom is dual core, and this is used to earth the output jack, as is shown in Mervyn Hisc--k's book. I can't work out how to do it with the single strand wire. Do I split the strand in two? Do I not need to earth it?? Feeling a bit lost.
Cold Sweat, Nailbomb 7b, Cold Sweat 7n

Transcend

what are you earthing? the guitar in general from the bridge to the pots?

Transcend

actally just re read your post.

every guitar ive owned has just had the single wire from the output jack for earthing to the pot.

I havent read the book to which you refer so i cant really help further sorry

Sifu Ben

So if I run a second wire from the jack to the volume will that do the job?
Cold Sweat, Nailbomb 7b, Cold Sweat 7n

Transcend

thats what i have always done whats your configuration pups/pots & switch wise?

Sifu Ben

Cold Sweat, Nailbomb 7b, Cold Sweat 7n


Philly Q

Quote from: Sifu Ben on September 26, 2010, 12:43:37 PM
So if I run a second wire from the jack to the volume will that do the job?

Yeah, just use two separate wires, that'll be fine.

As you've seen, a lot of manufacturers use a piece of shielded wire to connect to the jack, using the inner insulated wire for the hot connection and the braided outer shield for ground.
BKPs I've Got:  RR, BKP-91, ITs, VHII, CS set, Emeralds
BKPs I Had:  RY+Abraxas, Crawlers, BD+SM