• Welcome to Bare Knuckle Pickups Forum.
 

2 Humbuckers 2 vol 3 way blade switch

Started by Dormin, August 26, 2012, 06:23:43 PM

Previous topic - Next topic

Dormin

Hello folks  :D I just recently purchased a calibrated set of 2 conductor Aftermaths for my Ibanez  RGT42FX.  I want to attempt to wire these guys up my self but I'm a bit unsure of a proper way of doing it.  Basically I want a volume pot for each pick up, no tone pots and a 3 way blade switch (8 terminal) to go bridge bridge/neck neck.  I don't see a link to that exact schematic on the BKP site and after attempting on paper to make 1 line diagrams of how I think it should work, I'd rather ask for help from someone who may be sure how its done correctly,  thanks ^^

Frank

Uncle Seymour is here to help ...

http://www.seymourduncan.com/support/wiring-diagrams/schematics.php?schematic=2h_2v_2t_3w

Just omit the two tone pots, ground everything onto the backs of the volume pots. The red and white coil joins don't apply either as those are already done inside the pickup if it's two conductor.