• Welcome to Bare Knuckle Pickups Forum.
 

Wiring mistake?

Started by Pos, August 14, 2015, 10:11:55 PM

Previous topic - Next topic

Pos

Hi to everyone. I just swapped the old neck pup of my single cut with a BKP The Mule. I have 1 vol, 1 tone, 1 three-way miniswitch series/coil tap/parallel for the neck pup, and 1 two-way miniswitch series/coil tap. In the neck position, everything works fine: series, single and parallel modes all sounds fine. But, when I swap to middle position, the sound is too crispy and edgy than before.
For the neck mini-switch, I followed this diagram:
https://bareknucklepickups.co.uk/main/downloads/schematics/profiles/humbuckers/1hum__4_con_pushpull_pot-series_or_parallel.pdf
The red cable is soldered in the pin with the red cable from the selector, and black cable goes to ground on the tone pot. This is exactly as it was before pup swapping.
You can hear a couple of samples, both middle position neck parallel/bridge coil tap.
https://soundcloud.com/carlos-rivera-512/sets/asking-for-help
Did I do something wrong? Any Idea?
Thanx to anyone.

FIXED

Pos

Any idea? Please help.
If I won't receive any suggestion by thos evening, I think I willl try to swap the positives.

Pos

Just tried to flip the magnet inside. Tomorrow I'll check the wires, now I'm tired.

Pos

Soldered all the wires correctly. Doesn't sound soo different, it's just a little more smooth and less edgy. I undervalued the importance of pup adjustement. Setting up the pup and screws height brought very good results.