• Welcome to Bare Knuckle Pickups Forum.
 

Carlsbro PM10 circuit diagram

Started by psy, September 10, 2012, 11:55:58 AM

Previous topic - Next topic

psy

Hi,

Does anyone know where I can find a circuit diagram for a Carslbro PM10 stage monitor?  A cap has blown & I can't find the outer casing to see what size it was to replace it.

Cheers,

Simon
Cold Sweat set in Mockingbird NJ Classic > Boss GT6 > Sansamp PSA > VHT 2/90/2 > Zilla 2x12 cab > =D

HTH AMPS

Have you tried calling Carlsbro? - not trying to be a smart arse, but thats the most direct route imo.
[url="//www.youtube.com/TeleCustom72"]www.youtube.com/TeleCustom72[/url]
www.soundclick.com/bands/default.cfm?bandID=876738
www.facebook.com/pages/HTH-Amplification/263958270289235?sk=wall

psy

No, not yet.  I was hoping to just find a schematic online somewhere.  I'll try giving them a bell, they might even know why the capacitor in the same position has exploded twice now. :)
Cold Sweat set in Mockingbird NJ Classic > Boss GT6 > Sansamp PSA > VHT 2/90/2 > Zilla 2x12 cab > =D

jpfamps

I firstly assume the cap is an electrolytic.

If it's a signal/ decoupling cap, then it will most likely expire due to over voltage, although it can also expire if it is near a source of heat.

It is a filter cap it could also expire due to poor ripple current rating, which causes self heating.

I've seen quite a few piece of equipment where the voltage compliance of the caps is exceeded in normal use.

When you replace the cap I would go for 105degC cap (regular caps are rated at 85degC; all things being equal the 105degC cap will last 4 times as long as the 85degC cap) rated at a higher voltage.

Of course there could be another problem with the unit which is causing the cap to expire, but I would go down the uprating route first.
[url="//www.jpfamps.com"]www.jpfamps.com[/url]

psy

Hi JPF, yeah it's an electrolytic cap.  Thanks for the tip on using one rated for a higher temperature.  I remember it being 100v, but I don't remember the other figures on it at the moment.  As a general rule would putting a cap rated for a higher voltage in be a bad idea?  Just thinking if that couple with a higher temperature rating might double my chances of it not blowing again.

Cheers,

Simon
Cold Sweat set in Mockingbird NJ Classic > Boss GT6 > Sansamp PSA > VHT 2/90/2 > Zilla 2x12 cab > =D

jpfamps

Higher voltage rating is fine.

Lower not so good......
[url="//www.jpfamps.com"]www.jpfamps.com[/url]

HTH AMPS

Quote from: jpfamps on September 11, 2012, 11:52:46 AM
Higher voltage rating is fine.

Lower not so good......

Good for bonfire night  :lol:
[url="//www.youtube.com/TeleCustom72"]www.youtube.com/TeleCustom72[/url]
www.soundclick.com/bands/default.cfm?bandID=876738
www.facebook.com/pages/HTH-Amplification/263958270289235?sk=wall