• Welcome to Bare Knuckle Pickups Forum.
 

Piledriver/Stockholm problem

Started by Baby Evil, January 15, 2017, 01:52:12 PM

Previous topic - Next topic

Baby Evil

Hi

I've used my Piledriver/Stockholm combo in my Haar Tele for a long time succesfully.  I have had the body redone in another colour and a Duesenberg trem added, and after rewiring it, I have no signal, only a loud hum.
I checked and rechecked, so did another tech, and everything is wired correclty.
When I connect it to a tuner, it always indicates somewhere above a g. 

tx

Jan
SG700S: Abraxas; Haar Tele: Flat 50's; G&L Legacy: Crawler/Slowhands

Dave Sloven

I had this problem recently when I wired my Explorer up with a push-push 'blower' bypass switch.  Do you have any complex switching arrangements in there?  I took the push-push out and replaced it with a regular pot and then it was fine.

I only figured out that the problem was in the push-push because when the switch was engaged the hum got slightly louder.  Nothing else had any effect, just the same non-musical humming.
BLACK HAWKS
IMPULSES
COBRA-T
WAR PIGS
STOCKHOLM
COLD SWEATS
MIRACLE MAN
TRUE GRIT

[url="https://slovendoom.bandcamp.com/releases"]https://slovendoom.bandcamp.com/releases[/url]

Baby Evil

SG700S: Abraxas; Haar Tele: Flat 50's; G&L Legacy: Crawler/Slowhands

Dave Sloven

I'm guessing there's a ground loop in there somewhere.

Double check that you have the connections hooked up with the correct BKP colour codes.

If the wiring has no errors then it might be one of the pickups

The P-90s can come with either the two connector wiring with the braided ground or a three connector version with the shield.  If it is the latter just check that you have wired it up correctly.

If the pickups worked alright before I will assume that there was not a manufacturing fault.  It must have happened when it was put back together.  Check the bridge ground
BLACK HAWKS
IMPULSES
COBRA-T
WAR PIGS
STOCKHOLM
COLD SWEATS
MIRACLE MAN
TRUE GRIT

[url="https://slovendoom.bandcamp.com/releases"]https://slovendoom.bandcamp.com/releases[/url]

Baby Evil

I checked and rechecked, everything's wired right.
So I took the multimeter, and found that the poles of the P90 were connected to ground somehow.  That doesn't seem right.  I removed the P90 from the wiring, and I have perfect sound from the bridge now.



SG700S: Abraxas; Haar Tele: Flat 50's; G&L Legacy: Crawler/Slowhands

Dave Sloven

BLACK HAWKS
IMPULSES
COBRA-T
WAR PIGS
STOCKHOLM
COLD SWEATS
MIRACLE MAN
TRUE GRIT

[url="https://slovendoom.bandcamp.com/releases"]https://slovendoom.bandcamp.com/releases[/url]

Baby Evil

Apparently, it is due to a faulty neck pickup.  I measured it, and it's all over the place. 
I am going to try shorteninget the cable, maybe there is a bad contact because the solder went right through.

The guitar is as shielded as it was before
SG700S: Abraxas; Haar Tele: Flat 50's; G&L Legacy: Crawler/Slowhands

Dave Sloven

Try putting electrical tape under the pickup or painting the cavity with liquid electrical tape.  It might be the case that it's touching somewhere and that's causing an issue. If it works it's a cheap fix.
BLACK HAWKS
IMPULSES
COBRA-T
WAR PIGS
STOCKHOLM
COLD SWEATS
MIRACLE MAN
TRUE GRIT

[url="https://slovendoom.bandcamp.com/releases"]https://slovendoom.bandcamp.com/releases[/url]