¬¬
Bah, screw it:
The build is:
That there top, which is 5mm
on
three layered body, from the back
7.5mm maple
27.5mm meranti
5mm maple
+ top
Beveled edges, 15mm deep, 10mm across, so you can see the layering front and back, and heel-less.
Ergonomics cut out to also allow the layering to show, and allow the layering to make the tops of the horns trapezoids.
5pc through:
1/3 meranti
1/6 maple
1/6 walnut
1/6 maple
1/3 meranti
This is a (completely horrific) sketch I did when bob and I were working it out. It'll look, in general form, close to this. But not like a chimp drew it (it looks so much worse after scanning as well :(), and with ultra-cool woods. Didnt know the thickness of the layers as the time, adn thought the FB was gonna be ebony; bob came up with the one you see out of the blue later.
