Username: Password:

Author Topic: Help,I want to replace Burstbuckers with Bare Knuckles.  (Read 1966 times)

goatbreath

  • Strawweight
  • *
  • Posts: 1
Help,I want to replace Burstbuckers with Bare Knuckles.
« on: July 19, 2010, 04:54:43 AM »
I plain don't like the Toppy over trebly sound of the Burstbucker pros in my Gibson Les Paul Standard,they sound thin and lack mids.I have been looking on You Tube etc...To check out the sound of different Pick ups,It seems a toss up between Mules and Stormy Mondays.I don't want an overbright sound.I also want the bridge to be able to give some grunt.I don't want to have to roll all the treble off like I have to do with the Burstbucker Pro.I am aware of the Peter Green set.But they are unpotted.
       Also,some pick ups coil split well as far as the volume balance goes but some don't ,I know generally the lower the output,the less good the split normally.I sent my Burstbuckers to Wizard but they ended up sounding really weedy when split.I used to have an Ibanez with super 58s,these split well as does the Seymour Duncan JB/Jazz combo I have in my other Les Paul.The Super 58s were really good.They came with a Roadstar RS1010 Steve Lukather.The bridge was a bit overwound.
       So I am looking for a vintage sound I guess,but with versatility.I would like it to sound fat,warm and vintage accurate,especially warm.But I do want it to be able to rock on the bridge pick up if required.I hate that dry parched sound also.I'm not too fond of Billy Gibbons tone,that's what I mean by dry and parched.Peter Green,Camel,Wishbone Ash is my type of thing.

                                   Regards goatbreath.

                                         

Dreichlift

  • Bantamweight
  • **
  • Posts: 195
Re: Help,I want to replace Burstbuckers with Bare Knuckles.
« Reply #1 on: July 19, 2010, 08:24:48 AM »
You could get the Peter Green set and request that they be potted, BKP are very versatile in that respect.

ES330

  • Junior Flyweight
  • *
  • Posts: 12
Re: Help,I want to replace Burstbuckers with Bare Knuckles.
« Reply #2 on: July 24, 2010, 11:41:27 PM »
Just did that awhile ago.
The MULE neck is superb, but very thin in the bridge.
I recommend either a set of VHIIs, or a VHII bridge
with a MULE neck.

gwEm

  • Middleweight
  • *****
  • Posts: 7456
    • http://www.preromanbritain.com/gwem
Re: Help,I want to replace Burstbuckers with Bare Knuckles.
« Reply #3 on: July 25, 2010, 12:08:01 AM »
have a go with parallel rather than split wiring
Quote from: AndyR
you wouldn't use the meat knife on crusty bread but, equally, the serrated knife and straight edge knife aren't going to go through raw meat as quickly