Amp Settings

[38thBeatle]

On my Laney VC30, with my Fenders I tend to have:
Bass 5 to 6
Mid 5 to 6
Treble  4-5
With the Gibson I tend to go:

Bass 4
Mid 4-5
Treble 5-6

I don't have a presence and I do use volume and tone of the guitars a fair bit ( I am old fashioned).   
Not hard and fast- tend to vary according to venue but that is where I would start.
 

[Philly Q]

On my Cornell Romany with the tone stack switched out I have the volume at 6 o'clock. There aren't any other controls.

That sounds like my kind of setup!

[Matt77]

^
I like the sound of that.
I have a 5 way rotary tone and a volume on my MJW.
There's a Master Drive control as well
Pretty much all at 12 and a fuzz pedal for mayhem

[Ribboz]

My SLO:
Preamp: 11
Bass: 7
Mids: 3
Treble: 6
Presence: 8

With the cpig and full drive it will rip your $%&#ing head off. Haha :D

[Ratrod]

Engl Classic:

5 being center.

bass: 4
mids: 5
treble: 7 (6 if I play a Tele)
Deep switch: off
bright switch: on for humbucking, off for single coils
gain on low gain mode: 4
gain on high gain mode: 3

[mongey]

on my dual recto 3rd channel for heavy stuff

 in o'clock settings cause thats how I roll

prescence - 11.30
bass- 12.30
mid -11.30
treble-10.30
gain -2

with rectos cascading,stacked (whatever you call it )  eq/gain set up I find it better to dial the treble back and use the prescence for brightness . too high on the treble knob abd you dont get enough responce on the mids then bass knobs

[Dr.Pain]

I cheat, in a sense, and use the krank it preset in my Vypyr 60  :D